Tent canvas, exterior side view (rear)
3. From the interior, place the C-shaped end of the bed bow brace onto the bed bow
connector (Fig. A). Push the bed bow brace outward and upward while pressing the
second button from the curved end of the bed bow brace. Insert the end of the brace
into the bracket mounted on the shelf, just past the first button (Fig. B). Release the
button.
4. Attach the hinge cover to the bed board by placing the Velcro strip on the hinge cover
onto the Velcro strip on the bed board and pressing firmly.
5. Push the bed mats onto the bed board. Unfold the hinged mat and slide on to the bed
platform. Fold the canvas straps under the front edge of the small bed mat.
Condensation can be prevalent if proper ventilation is not used. It can exist whether or not
a heater is used. We recommend that you leave a small opening in each bunk zipper to
permit air to flow through and allow the tent to “breathe.” This will help minimize
moisture gathering above the bunk area on the vinyl (see Condensation).
Zipper shown open to
allow air to circulate
To Next Page
Loading...
