Fig 8.1 Water pump
Water pump
WATER PRESSURE REGULATOR (CUSTOMER SUPPLIED)
Excessive pressure from the water supply source may be encountered in some parks,
especially in mountain regions when using the fresh water inlet or black tank flush. Water
pressure regulators are available to protect your recreation vehicles plumbing system
against such high pressure.
Fresh Water Connections
Your recreation vehicle may be equipped with one or both of the following fresh water
connections: City Water and Gravity Fill. The City Water Fill has a threaded connector
with a City Water Connection label next to it. Do not remove this label.
Using City Water Fill:
1. If needed sanitize the water system. (Refer to
Sanitizing the Plumbing System section)
2. Remove the connection cap and attach a non-
toxic drinking water hose to the threaded inlet.
NOTE: The other end of this hose should be
connected to a pressurized fresh water source
e.g. faucet or spigot).
NOTE: You should use a non-toxic
drinking water hose dedicated only to supplying
fresh water to the vehicle. To reduce the change
of contamination, prevent the non-toxic drinking
water hose from coming into contact with the ground.
CAUTION
A water pressure regulator is recommended to prevent damage to the plumbing
system or components. To prevent damage when using the city water connection, a
45 lb. (315 KPa) rated water pressure regulator is recommended.
To Next Page
Loading...
Need help?
General
