SECTION 12 – INTERIOR CLASS C MOTOR HOME
12 - 2
FURNITURE UPHOLSTERY
To retain the value of your motor home, maintain the furniture upholstery carefully
and keep the interior clean. Vacuum the furniture regularly using a soft brush
attachment to remove any loose dirt or debris.
Fabric (if so equipped)
It is recommended the fabric be professionally cleaned if it becomes stained or
soiled. The professional cleaner should be made aware the fabrics have been
treated to be fire resistant. For more information, refer to the specific furniture
manufacturer’s care instructions.
Ultraleather™ (if so equipped)
It is recommended the Ultraleather™ be professionally cleaned if it becomes
stained or soiled. For more information, refer to the specific furniture
manufacturer’s care instructions.
Leather (if so equipped)
Periodic vacuuming, using a dry cloth to wipe up spills immediately, and using a
damp cloth on problem areas, will help to keep your leather furniture in good
condition. Leather surfaces can vary as do the cleaning methods. Refer to the
furniture manufacturer’s recommendation, or consult a cleaning professional.
It is recommended you do not use any cleaners containing oils, waxes or silicones.
Cleaners containing silicone can eventually destroy the finish on the leather.
Cleaners containing oils or waxes leave residues on the surface of the leather
which can attract more dirt which can eventually lead to cracking.
BED STORAGE
Additional storage has been provided under the bed. It is equipped with gas struts
to assist with easy access. To access the storage area, grasp the end ledge at the
foot of the bed and lift carefully. To close, carefully push down on the bed slowly
easing it to the closed position.
The bedroom electric slide room system may be located under the bed. If so, it can
be accessed by removing the screws holding the wooden paneling in place. Use
care not to obstruct the slide room system when using the under bed storage area.
PRIVACY DRAPE INSTALLATION
Remove the privacy drape from the storage bag, which you should find in the
storage area under the mattress platform in the bedroom.
Starting at the driver's side of the cab, attach the black plastic hook to the loop
attached to the wall behind the driver's seat. Make sure that the side of the drape
with Velcro® is facing the motorhome windshield.
1. Pull the drape toward the front of the motor home and behind the driver's side
sun visor. Open the sun visor against the windshield to hold the drape in place.
CAUTION
Before lifting, be sure there is nothing on the bed that will restrict its
movement or add extra weight. Use caution when opening or closing the bed
to keep hands and fingers at the end ledge provided (not on the side or
further back than necessary) to avoid pinch points
.
To Next Page
Loading...
Need help?
General
