CLASS C MOTOR HOMES SECTION 5 - SLIDEOUT SYSTEMS
5 - 3
Your slideout system has been designed to require very little maintenance. To
ensure a long life of your slideout system, read, understand and follow these
simple instructions. This system contains a pre-lubed bearing that is lubricated
when the room is moved in and out. Do not spray oil or grease on the rails while
the room is extended.
TROUBLESHOOTING THE SLIDEOUT
If the slideout does not move when the slideout switch is depressed, follow these
steps.
Check the auxiliary battery (customer supplied) for a full charge and good
wire connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.
If the slideout is extended, refer to the following section on overriding the
specific slideout system installed on your RV.
If the slideout is retracted, leave it in that position.
Contact your dealer or Jayco Customer Service for repair assistance.
If the slideout extends crooked or only one side moves, follow these steps.
Follow steps on overriding the specific slideout system installed on your RV.
You may need to push the side that is not sliding to get it to retract all the
way.
Contact your dealer or Jayco Customer Service for repair assistance.
Slideout override
Locate and remove the access panel for the slideout motor.
Fig. 5.5 Main room slideout motor
1. From the rear of the motor, rotate the brake release lever counter-clockwise
1/8 turn. This will release the brake that locks the slideout in place.
2. Disconnect one slideout motor wire near the motor.
WARNING
Do not work on your system unless the battery is disconnected. Failure to
com
To Next Page
Loading...
Need help?
General
