CLASS C MOTOR HOMES SECTION 4 - VEHICLE OPERATION
4 - 5
The following label should be kept permanently affixed by the leveling jack control
panel located in the command center:
Fig. 4.1 Leveling jack label
To manually override
Before attempting to override the semi-automatic hydraulic leveling system ensure
the area around the motor home is clear of others, including children and pets. In
the event the hydraulic leveling jack control panel will not retract the jacks, the
jacks can be retracted using the auxiliary valves at the hydraulic pump connection.
Refer to the manufacturers user guide for detailed operating and safety
information.
CAUTION
Never expose hands or other parts of the body near hydraulic leaks. High-
pressure oil leaks may cut and penetrate the skin causing serious injury.
CAUTION
Never lift the wheels off the ground when leveling the motor home.
WARNING
After starting the leveling cycle it is very important you or other occupants
do not move around in the motor home until the vehicle is level. Failure to
remain still during the leveling cycle can affect the leveling jack system
sensors.
Do not move the motor home while the jacks are still in contact with the
ground or extended. Damage to the vehicle could occur.
Do not rely solely upon warning lights to determine the position of the
leveling jacks. It is the operator’s responsibility to check that all the
leveling jacks are fully raised in the travel mode before moving the motor
home.
WARNING
Use extreme caution when overriding the hydraulic leveling jack pump.
Ensure that no one becomes trapped under the motor home or by the
entrance steps (if extended). It is highly recommended you have
someone assist
To Next Page
Loading...
Need help?
General
