FULL BASEMENT MODELS:
•
Connect a garden hose to "Fresh Water Connection" (Fig. 4-3D) inside the utility center.
•
Move the "Fill Water Tank Handle" (Fig. 4-3B) to the "Fill Water Tank Position" (Fig.
4-3A).
•
Open the valve on the water supply line.
•
Enter the unit and open faucets to bleed air from lines. The water heater will fill first,
followed by the supply lines and faucets. When the lines are near full, you may
experience some air pockets. Allow them to escape before closing the faucets.
•
Return the "Fill Water Tank Handle" to the normal position (Fig. 4-3C).
I
CAUTION: Excessive pressure from the water supply may be encountered in some parks,
especially in mountain regions. Water pressure regulators are available to protect your
system against such high pressure. A regulator of this type is recommended to prevent
damage to plumbing systems or components.
The Systems 29
Fig. 4-3
To Next Page
Loading...
Need help?
General
