Full Basement Models
NON-UTILITY CENTER
1. Drain the water tank and water heater completely by turning all faucets on until tank and
heater are empty.
2. Open the low point drain valves located in the utility center. When water stops flowing out of
them, close the valves. (Fig. 4-27)
3. Open water heater bypass valve K and close valves I and J. (Fig. 4-29)
4. Turn the "Winterizing Valve" to the "Sanitize/Winterize Intake" position. (Fig. 4-27C)
5. Turn "Fresh Water Inlet Valve" to "Fill Water Tank" position.
6. Close valve H and G. (Fig. 4-28)
7. Open "Water System Valve." (Fig. 4-28F)
8. Put the clear antifreeze hose into a jug of non-toxic RV antifreeze. You will need more than
one gallon of antifreeze. (Fig. 4-27A)
I
WARNING: Do not use Ethylene Glycol (automotive antifreeze) or methanol
(windshield washer fluid) in your fresh water system. They are harmful and can be
fatal if ingested.
9. Turn the "Water Pump Switch" to the "ON" position and open each faucet until the antifreeze
flows through. Do not forget to run the antifreeze through toilet. (Fig. 4-27D)
10. Pour at least one cup of antifreeze into each drain to protect the P-traps.
11. Before using the water system again, open the water heater bypass valves I and J, close
valve K. Open valve F, sanitize and flush the whole system. (See instructions under
"Sanitizing")
The Systems 43
Fig. 4-27
Fig. 4-28
Fig. 4-29
To Next Page
Loading...
Need help?
General
