Outside Shower (Option on some models)
A convenient faucet assembly with hot and cold water is
available for exterior use washing or rinsing on the outside of the
motorhome. (Fig. 4-7 - non-basement models) For full basement
models, the outside shower is located with the other controls.
OPERATION
1. Turn on the pump.
2. Open the door with the key and allow it to hinge down; or
on units with the utility center, open the door to the utility
center.
3. Remove the shower head and open the valve.
4. Open the faucet valves and adjust to the desired
temperature.
5. To cease the operation close the valve(s) on the faucet and allow the water to drain from the
shower head.
6. Close the valve on the shower head.
Any water remaining in hose will drip or run out of the vacuum breaker. This is NOT a leak but
performs as intended. Water in A.B.S. plastic box will drain out along the outer edge. The shower
head can be removed to drain the hose faster. Replace the shower head and the hose inside the
compartment. Keep the door closed when not in use for sanitary reasons.
NOTE: To close the door on the outside shower, do not place the shower head on the
bracket. This will cause the shower head to be in the way of closing the door
properly.
Sanitizing and Filling the Potable Water System
For your safety, you should sanitize your potable water system when your RV is new, every three
months or 3,000 miles (5,000 kilometers), when it has been sitting unused for a period of time, and
any time it may have become contaminated.
32 Type C Owner’s Manual
Fig. 4-8
To Next Page
Loading...
Need help?
General
