Wheel Liners
Your recreation vehicle may be equipped with Versa-Liner Wheel Liners. The following
instructions will give you direction for removing and reinstalling the wheel liners when necessary.
VERSA-LINER® WHEEL LINERS
NOTE: DO NOT loosen or remove lug nuts. Set the vehicle parking brake prior to wheel
product installation.
NOTE: These wheel liners can be installed with the installation tool supplied with the
wheel liner kit. Keep this tool stored with your vehicle tire tool. No other tools
are necessary to remove or install the wheel liners. Do not use power tools for
installation or removal
INSTALLATION:
1. FRONT - Align the valve stem cut out in the front Versa-Liner with the valve stem on the
wheel.
2. Secure with two enclosed steel jam nuts. Securely tighten each jam nut with the installation
tool provided.
3. REAR - Align the openings in the rear Versa-Liner with the openings in the wheel.
4. Mount the rear Versa-Liner using two lug nut covers with the enclosed steel jam nut and the
installation tool provided.
NOTE: Check for tightness after the first 50 to 100 miles of operation. Recheck
periodically.
Reverse the installation process to remove the wheel liners.
CARE AND MAINTENANCE:
• Clean only with a mild soap and water.
• Do not use harsh detergents, acids or abrasives.
Periodically check the enclosed jam nut for tightness.
86 Type C Owner’s Manual
To Next Page
Loading...
Need help?
General
