I
WARNING:
• Use care when lighting a top burner by hand. If the burner lights
unexpectedly, or your hand is close to the burner, you may be burned.
• Burner flame should not extend beyond the edge of the cooking utensil.
The flame could burn you and cause poor cooking results.
• Be sure all control knobs are turned to OFF when you are not cooking.
Someone could be burned or a fire could start if a burner is accidentally
left ON.
• Do not heat unopened containers. They could explode. The hot contents
may cause burns and container particles may cause injury.
• Do not store flammable materials on, in, or near range or cooktop. Any
fumes can create an explosion and/or fire hazard.
NOTE: Check that the gas is on at the shutoff valve.
LIGHTING Top Burners:
a. All burner controls operate counter clockwise and must be pressed inward (toward the
cooktop) to turn ON or LITE. Do not attempt to light more than one burner at a time.
b. IMMEDIATELY light the burner by holding a lit match or a hand held spark igniter
designed for this purpose near the burner ports.
c. To extinguish the top burner flame, turn the appropriate burner knob clockwise to OFF.
LIGHTING Top Burners with spark ignition:
a. Turn the appropriate burner knob counter-clockwise to ON or LITE. Do not attempt to
light more than one burner at a time.
b. Turn the SPARK knob clockwise one “click”. If the burner fails to light, continue turning
the SPARK know clockwise until the burner lights.
c. To extinguish the top burner flame, turn the appropriate burner knob clockwise to OFF.
LIGHTING Top Burners with electronic ignition:
a. Turn the appropriate burner knob counter-clockwise to ON or LITE. This will
automatically activate the ignition system, and all burners will begin to spark repeatedly.
This is the “clicking” sound you will hear.
b. The burner will light within (5) seconds. Once the burner is lit, turn the knob
counter-clockwise to the desired setting.
c. To extinguish the top burner flame, turn the appropriate burner knob clockwise to OFF.
d. If 12-volt DC power is not available to the ignition module for any reason, the top burners
will be lit manually. See instructions in “Lighting Top Burners” (above).
I
CAUTION: Do not cook with the control knob set in the LITE position. Damage to the
ignition module and burner electrodes may result.
Ranges are supplied with proportional flow (linear) top burner valves. Start cooking at the HI
setting, then turn the control knob counter-clockwise to continue cooking to obtain best results. Use
the following table as a guide until you get used to the setting.
66 Type C Owner’s Manual
To Next Page
Loading...
Need help?
General
