EasyManuals Logo

Jayco Greyhawk User Manual

Jayco Greyhawk
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
The controls select the energy source in this sequence:
When 120-volt AC is available to the refrigerator:
The light bars beside AUTO and AC show in the center display.
After ten seconds, the light bar beside AC goes off and only the light bar beside auto
remains.
This means that the refrigerator is operating on AC electric.
If 120-volt AC is not available to the refrigerator:
The light bars beside AUTO and LP GAS show in the center display.
After ten seconds, the light bar beside LP goes off and only the light bar beside AUTO
remains.
This means that the refrigerator is operating on propane gas.
If an energy source is available to the refrigerator, but is not operating correctly:
A fault code appears in the center display.
The refrigerator controls try to change to a less efficient energy source.
If a less efficient energy source is not available:
The refrigerator stops operation.
Refer to the “Fault Codes” in the manufacturer’s owner’s manual.
MANUAL MODE OPERATION
When you select one of the manual modes of operation, the light bar beside the AUTO goes out in
the center display and only the light bar beside either AC, LP, or DC remains.
AC means that the refrigerator is operating on AC electric.
LP means that the refrigerator is operating on propane gas.
If the energy source is interrupted:
The refrigerator stops operation.
Refer to the “Fault Codes” in the manufacturer’s owner’s manual.
OPERATION OF PROPANE GAS IN EITHER AUTO OR MANUAL MODE
NOTE: On initial start up of the refrigerator, ignition of the propane gas may not occur
within 30 seconds.
If ignition of the propane gas does not occur within 30 seconds:
The gas safety valve of the refrigerator closes.
The refrigerator stops operation.
Refer to the “Fault Codes” in the manufacturer’s owner’s manual.
The fault code remains until you push the ON/OFF button two times (to stop and start the
refrigerator).
If ignition does not occur after two or three times:
Check the gas supply line.
Consult your local dealer or an authorized Norcold Service Center.
Change to manual mode and operate on AC electric.
78 Type C Owner’s Manual

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jayco Greyhawk and is the answer not in the manual?

Jayco Greyhawk Specifications

General IconGeneral
Fuel TypeGasoline
ManufacturerJayco
ModelGreyhawk
ChassisFord
EngineFord V10
Horsepower305 hp
Length31 ft
CategoryClass C
GVWR14, 500 lbs
GeneratorOnan 4.0 kW
Grey Water Capacity39 gallons
Black Water Capacity39 gallons

Related product manuals