of
ANSI
Standard
A119.2,
The National Electrical Code and
Canadian Standards Association.
Your new Jayco tent camper is equipped with
a
15-amp
power cord
to connect from the campground outlet to your
camper,
the
power
cord is pre-wired into
the
distribution panel with a 15-amp
overcurrent protection breaker and then supplies 120-volt
AC
to the
12-volt
DC
power convertor.
To prevent accidental electrical shock, insure that the ground pin
on
the
attachment
plug
cap is intact to the earth ground through
the
R.V.
park receptacle. When plugged into
a
receptacle
with
no
provision for the third pin, use an adapter
with
a
pigtail that can
be connected
to
the receptacle
box,
with
the grounding
circuit
completed through the ground pin or
R.V.
park receptacle
box,
any
accidental short of a
live
circuit conductor will trip the circuit
breaker indicating a shorted circuit. You should
be
certain that the
polarity of the external power is not reversed,
in
order to avoid
harm to appliances and personal electrical shock. Polarity
indicators
may
be purchased in many electrical and hardware
stores.
Plug
ANSI
C73.13
-
IZQV,
15
Amps.
2
Pole.
3
Wire
Graundrng
Type
CHANGES,
MODIFICATIONS,
AM)
ADDITIONS
Any changes or additions made
after
delivery
may develop a
hazardous condition.
Be
sure to consult your local authorized
dealer. Only qualified electrical technicians should attempt
to
make changes, or additions to our electrical system, using only
approved materials
and
components and employing approved
methods of installations.
Extension cords should
always
be a heavy gauge of wire
equal
to
the power cord.
Usage
of
too
small
a
cord
will
result
in
overheating and possibly burning of the cord.
DO
NOT
leave an
unused portion of an extension cord
in
a
coil as it will overheat and
short
out
wires.
To Next Page
Loading...
Need help?
General
