100
Toilet
Prior to using the sanitation system, it is strongly recommended to ush the toilet several
times to release sucient water into the holding tank. Generally, more water is required only
when ushing solids.
The toilet system will perform better when water is run for ten to fteen seconds after ush-
ing to ensure that the waste will proceed to the bottom of the tank.
If there is not a sucient amount of water used during ushing, the waste materials may not
evacuate properly from the drain line to the tank. Clogged tanks and pipes could eventually
occur. For added convenience and better sanitation system performance, it is advisable to
always have four to six inches (10 - 15 cm) of water in the toilet. It is important to add
enough water to prevent solid waste buildup. The following guidelines will help to prevent
solid waste buildup.
Tank Heaters
Your recreation vehicle may be equipped with heaters for the fresh, gray, black water tanks.
These heaters will prevent water in the tanks and lines from freezing down to -11°F (-24°C)
(contingent on recreation vehicle setup).
The larger tank heaters are 120VAC and attach directly to the tanks. The thermostat con-
trolled tank heaters will cycle on at 44°F (7°C) and o at 64°F (18°C). All of the heaters are
controlled by a single ON/OFF switch that is typically located on the command center panel
or in the bathroom. The switch lights up red when ON and controls the heater circuit.
When liquid is present in the holding tanks and the outside temperature approach-
es and maintains freezing conditions 35°F (2°C) or colder.
When there is NO liquid present (tanks are empty).
When dumping the black and gray holding tanks and the drain pipes.
When fresh water tank and supply lines are empty or being drained for storage.
When the recreation vehicle is connected to city sewer and the gate valves are
open.
When ambient temperatures rise and remain above freezing.
No maintenance on the heaters is required, only a periodic inspection for loose wires, dam-
age, etc. For additional detailed information, refer to the tank heater manufacturer’s user
guide.
In order for the 120VAC tank heaters to be in operation, the recreation
vehicle be hooked up to shore power or under generator power.
If the recreation vehicle is not operating on shore power or generator
power,
The red light on the command center tank switch does not necessarily
indicate that heaters are operating; it is only a warning that the
heater circuit is ON.
To Next Page
Loading...
Need help?
General
