83
The water heater switches are typically located on the monitor panel. Refer to the Monitor
Panel section for function details.
Sanitizing and Winterizing
Water valve settings indicated on the utility center label:
- Allows you to access water from all fau-
cets using a pressurized water source (referred to from
here on as “city water”).
- Allows you to ll your fresh water tank
using city water.
- Allows you to siphon ll your fresh water
tank (using the 12-volt water pump) when you do not
have access to city water.
- If the RV is not connected to city water, allows
you to pump water from the fresh water tank to
all faucets using the 12-volt water pump.
– Allows you to sanitize or
winterize the water lines.
– Allows you to sanitize the fresh
water tank. Depending on your model, the city
water connections may be congured one of three
ways:
1. . The city water
connection inlet will be located on the outside of the
motor home, and the pump switch inside on the moni-
tor panel.
2. ). This utility center
contains the city water connection inlet, pump switch,
water valve controls, outside shower, black tank ush
inlet and a macerator discharge system.
To Next Page
Loading...
