JB Pipepuller l Maintenance
19
MAINTENANCE
Battery
The JB Pipepuller is powered by an Interstate SRM-4D deep cycle battery.
It has 1645 cranking amps and 1314 cold cranking amps. It is recommend-
ed that the battery be fully charged at the end of its daily use. It is recom-
mended that the battery be charged at a slow rate, preferably in deep cycle
mode. An automatic charger is highly recommended. The water level in the
battery should be checked periodically. If taken care of properly, this battery
will give you many years of service.
Hydraulics
The JB Pipepuller is powered by a Monarch DC power unit capable
of putting out 3000 psi. The recommended oil for this unit is Dextron IV.
Before adding any oil, always have the cylinder in the closed position.
It is critical to ensure no dirt or debris is introduced into the system
while adding oil. Contaminated hydraulic oil can cause failure of the
hydraulic system.
To Next Page
Loading...