EasyManua.ls Logo

JB Pipepuller 1700 - User Manual

JB Pipepuller 1700
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MODEL 1700
OPERATOR’S MANUAL
The New Generation of Pipe Pullers
MADE IN THE USA
PATENT #6969217
Revised Addition 02 - October 2017

Table of Contents

Questions and Answers

  • T
    timothyjonesAug 2, 2025
    Why is the power unit not running on my JB Pipepuller 1700?
    • C
      Crystal DaughertyAug 2, 2025
      If the JB Pipepuller Construction Equipment's power unit isn't running, several factors could be at play. First, verify the 12-volt battery's charge and replace or charge it if it's low. Check the remote battery and replace it or use an extension cord if needed. Inspect the 10 amp fuse and change it if blown. Ensure sufficient battery connection by cleaning and tightening connections. Also, clean and tighten the ground connection to the frame. Finally, check all connections and inspect the wiring for any loose or broken wires.
  • R
    Richard FrankAug 16, 2025
    What to do if cylinders will not operate on JB Pipepuller Construction Equipment?
    • T
      tina67Aug 16, 2025
      If the cylinders on your JB Pipepuller Construction Equipment aren't operating, begin by checking the 12-volt battery charge, replacing or charging if low. Also, check the remote battery, replacing it or using an extension cord if necessary. Inspect the 10 amp fuse and replace it if blown. Ensure a good battery connection by cleaning and tightening. Also, verify the ground connection to the frame is clean and tight. Check the hydraulic oil level and add oil if it's low. Lastly, inspect the hydraulic hose for any pinches or obstructions; replace the hose or clear any obstructions found.

Summary

JB Pipe Puller Specifications

Safety

Safety Alert Symbols

Explains the meaning of various safety alert symbols (e.g., Warning, Caution, Danger) used in the manual and on the equipment.

Safety Warning Decals

Highlights the importance of safety decals on the pipepuller and the operator's responsibility to review them.

Training Safety Guidelines

Details safety instructions and best practices for operators, emphasizing familiarization with controls and emergency procedures.

Pre-Work Safety Review

Provides a checklist for pre-operation safety review, covering manual understanding, work area clearance, and equipment setup.

Parts Description

Operation

Setting up the JB Pipepuller

Wheel Adjustment Procedure

Details the procedure for adjusting the pipepuller's wheels based on culvert type and height.

Setting the Post Height

Explains how to measure culvert height and set the appropriate post height using the adjustment chart.

J-Link & J-Hook Selection

Cylinder Selector Valve Operation

Lower Puller into Culvert

Set up J-Links and Lock Puller in Position

Attach 2 nd J-Link

Release Pipepuller and Reposition

Maintenance

Post Adjustment Charts

Troubleshooting

Power Unit and Cylinder Operation Issues

Addresses common problems with the power unit not running or cylinders not operating, with possible causes and solutions.

Strut Setting Issues

Troubleshooting steps for when the strut does not set correctly, including post and cylinder positioning.

Cordless Remote Wiring Diagram

Presents the wiring diagram for the cordless remote push button control system.

Corded Remote Wiring Diagram

JB Pipepuller 1700 Specifications

General IconGeneral
BrandJB Pipepuller
Model1700
CategoryConstruction Equipment
LanguageEnglish