Troubleshooting
Troubleshooting l JB Pipepuller
26
PROBLEM POSSIBLE CAUSE SOLUTION
Power unit will not run 12 volt Battery Low on charge Charge battery or replace
Remote battery is low on charge
Replace battery or use extension
cord remote
10 amp fuse is blown Change fuse
Insufficient battery connection Clean and tighten battery connections
Improper Ground connection to frame Clean and tighten all connection points
Loose or broken wire
Check all connections and inspect wire
for breaks
Cylinders will not operate 12 volt Battery Low on charge Charge battery or replace
Remote battery is low on charge Replace battery or use extension
cord remote
10 amp fuse is blown Change fuse
Insufficient battery connection Clean and tighten battery connections
Improper Ground connection to frame Clean and tighten all connection points
Hydraulic oil low Add oil
Hydraulic hose pinched or obstructed Change hose or clear obstruction
Strut does not set Improper post setting Refer to Post setting chart
for proper setting
Strut Cylinder is not fully extended Extend the cylinder to its full extension
Strut cylinder not closed before Retract cylinder before you shove the strut
engagment of ceiling to the cylinder
Improper wheel setting Read manual for proper setting
To Next Page
Loading...