ENGLISH
AX700 2
GENERAL
• AX700 Input Section is constructed by J-type fet tube and advanced
OP Circuit, together with DC Servo power. AX700 has a high
impedance, low noise and large range of frequency response.
AX700 has a protection function as follows:
• Power ON/OFF transmission, prevents against surges.
• DC protection at speaker output: the amplifier will automatically cut
off the link with the speakers when the amplifier has a defect.
• Thermal cut off protection: the amplifier will automatically cut off the
link with the speakers when the temperature is more than 85°.
• Short circuit current limited protection.
PRECAUTIONS
• Don’t put anything on top of the amplifier.
• Always use a power source of adequate capacity.
• Wait several minutes when turning the power amplifier ON/OFF
continiously.
• Don’t let the ventilation holes on the body of the amplifier get
• obstructed in any way.
• Input level can be adjusted via the gain switch of each channel.
• Output can be used with phone Jack or speakon.
• Don’t obstruct the cooling system on the rear panel.
• Before cleaning the amplifier, turn it off and cut off the power supply.
Wipe it with a dry cloth. Don’t use solvent or a chemical cloth.
• If there is a defect, disconnect the power cord and contact your
dealer.
To Next Page
Loading...
Need help?
General
