JBL ESC333 - Basic Operation; Master Power Switch

-8-
three.Operation
Master On/Off Switch
To operate unit, place this switch in the
On/Standby position. The system will go into
standby when no signal has been received and
when no unit connected to any of its two digital
inputs has been on for approximately five minutes.
Rear-Panel Control
Remote-Control-Battery Replacement (for future reference).
+
+
+
Push small tab towards
battery slot and pull battery
drawer out.
Remove old battery.
Insert new battery with “+”
side up, and slide battery
drawer back into remote.
ESC333 Simply Cinema OM 5/24/00 12:17 PM Page 8