JBL LSR28P - Page 69

JBL PROFESSIONAL
ELECTRONIC FAILURE
Q.A. CODES
31
July 1, 2002
Page 2
Q.A.
CODE
DESCRIPTION OF DEFECT WARRANTY
STATUS
Q.A.
CODE
DESCRIPTION OF DEFECT WARRANTY
STATUS
10.130 CONNECTOR (Specify)
10.192 Cables - Noisy IN
10.131 Connector - Intermittent IN 10.193 Cables - Cut - Partially Open IN
10.132 Connector - Broken IN 10.194 Cables - Connector Installed Wrong IN
10.133 Connector - Missing Pins IN 10.195 Cables - Burned IN
10.134 Connector - Installed Backwards IN
10.135 Connector - Loose IN
10.200 Components/Touching Shorted
10.140 PCB (Specify) 10.300 SOLDER PROBLEMS (Specify)
10.141 PCB - Broken Trace IN 10.301 Cold Solder IN
10.142 PCB - Burned Trace * OUT 10.302 No Solder IN
10.143 PCB - Cracked IN 10.303 Splashes IN
10.144 PCB - Bad Feedthrough/via IN
10.145 PCB - Chemical Damage IN
10.400 MECHANICAL – (Specify)
10.146 PCB - Exchange Amp Board IN 10.401 Broken Binding post IN
10.147 PCB - Exchange Signal Input Board IN 10.402 Broken Fuse Holder IN
10.148 PCB - Exchange DSP Board IN 10.403 Open Line Cord IN
10.149 PCB - Exchange A/C Input Board IN 10.404 Broken/Missing Knob IN
10.405 Dented Chassis OUT
10.150 REGULATORS – (Specify)
10.406 Damaged Front Panel OUT
10.151 Regulators - Open IN 10.407 Broken Fan OUT
10.152 Regulators - Burned * OUT 10.408 Stopped/ Slow Fan IN
10.153 Regulators - Shorted IN 10.409 Packing IN
10.154 Regulators - Thermally Sensitive IN 10.410 Noisy Fan OUT
10.155 Regulators - Noisy IN
10.156 Regulators - Broken IN
10.500 SOFTWARE (Specify)
10.157 Regulators - Out of Regulation IN 10.510 Upgrade Software IN
10.158 Regulators - Wrong Part IN 10.520 Upgrade Hardware IN
10.530 Reset to Factory Software IN
10.160 BULB/LAMP - (Specify)
10.161 Open IN
10.600 ADJUSTMENT (Specify)
10.601 Adjust Voltage IN
10.170 TRANSFORMER - (Specify)
10.602 Adjust Bias IN
10.171 Transformer - Open IN 10.603 Adjust Meter IN
10.172 Transformer - Burned * OUT 10.604 Adjust Chassis IN
10.173 Transformer - Noisy IN
10.174 Transformer - Shorted IN
10.700 MISC/HARDWARE (Specify)
10.175 Transformer - Loose IN 10.701 Screw - Missing (from factory) IN
10.702 Screw - Broken (from factory) IN
10.180 CRYSTAL - (Specify)
10.703 Screw - Loose (from factory) IN
10.181 Crystal - Dead IN 10.704 No Problems Found
10.182 Crystal - Wrong Frequency IN 10.705 Return As Is
10.183 Crystal - Thermally Sensitive IN 10.706 Customer Attempted Repairs OUT
10.707 Received in for Repairs Missing Parts OUT
10.190 CABLES - (Specify) *COULD BE CONSIDERED IN-WARRANTY AS
10.191 Cables - Open IN
DETERMINED BY TECHS EVALUATION