EasyManua.ls Logo

JBL PSW-D110 - Page 5

JBL PSW-D110
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Limiter (yes/no)
Yes
THD at Max. Output
Power
10
% Maximum Output Power Maximum THD as a result of limiting.
Features
Phase Switch (yes/no)
yes
Volume pot Taper
(lin/log)
linear
Input Configuration
Line In
(L,C,R,AC3,Mono)
L,R
Enabled w/Line/Spkr Input
Select Switch
Line Outputs (L,C,R)
L,R
Buffered Output / Pre-Volume control
Line-Out Adj. X-over
130-240
Hz
Var-HPF (Pot CCW and CW
positions)
Rear panel Variable xover
Spkr/Hi Level In
(L,C,R,mono)
L,R
Enabled w/Line/Spkr Input
Select Switch
Spkr Out: Hi Pass Filter
100
Hz
8 ohm Satellite: 6dB/oct
passive xover
Driven from zero ohms source impedance
Signal-Present LED Bi-Color LED (green=signal/ red=no signal)
Signal-Present Input
Freq.
100
Hz Nominal 200uF Series Cap on PCB
Signal-Present Level
2
mV
100Hz into Line Input w/ 1 ch.
driven
Signal-Present
Bandwidth
1k
Hz
Signal-Present-LPF for noise
immunity
Signal-Present Turn-on
time
1
sec. Amp connected and AC on, then input signal applied
Auto Mute/ Turn-OFF
Time
15
min.
T before muting, after signal
is removed
Power on Delay time
3
sec. AC Power Applied
Transients/Pops
Signal-Present Transient
5
mV-peak @ Speaker Outputs
Turn-on Transient
500
mV-peak @ Speaker Outputs AC Line cycled from OFF to ON
Turn-off Transient
500
mV-peak @ Speaker Outputs AC Line cycled from ON to OFF
Efficiency
Stand-by Input Power
17
Watts @ nom. line voltage
AC Power Cons.@1W
18
Watts @ nom. line voltage
Power Cons.@rated
power
107
Watts @ nom. line voltage
Efficiency
70.09%
% Relative to 75w output
Protection
Short Circuit Protection yes Direct short at output
Line Fuse Rating 1.25 Amps Type-T or Slo Blo
5
Amplifier/Subwoofer PSW-D110/DPS-10

Other manuals for JBL PSW-D110

Related product manuals