· 5 ·
INSTALLATION
As a centering tool, this kit provides two operation methods:
METHOD 1:
Using centering tools:
- After you choose the centering method, insert the centering tool into the clutch disc.
- Put in the clutch pressure plate.
- Put on place the studs, alignment plate, special nuts and handle.
- Turn the handle clockwise to make pressure onto the diaphragm.
- Screw the bolts into the clutch pressure plate.
- Turn the handle anti-clockwise to release pressure from the diaphragm.
- Remove the nuts, alignment plate and studs.
- Screw remaining bolts.
- Pull out the centering tool.
- With the help of the clutch reset tool, bring the springs to its initial position.
METHOD 2:
Assembling the parts this way to build the centering tool:
To Next Page
Loading...