14 Please see operator manual for full details.
1
4
7
2
5
8
3
6
ROPS upright
Drive selection
Select forward
drive/reverse
Battery isolator on
Engine pre-heat
Accelerator pedal
Fasten lap belt
Machine start
Make sure the ROPS
(Roll-Over Protective Structure)
is in the upright position.
Make sure the drive lever is in
the neutral/park position.
Set the drive lever to
forward/ reverse position.
Press the pedal to move the
machine, depress to brake/stop
the machine.
Turn and hold the ignition key
to position 2 and wait for the
pre-heat light to go off.
Turn ignition key to position 3
to crank the engine.
Make sure the battery isolator
key is installed and switched on.
The operator should be seated
with the lap belt engaged.
Start-up sequence
To Next Page
Loading...
