JCB, SO53 3LE
www.jcb-tools.com
Customer Helpline 0333 0143092
WORK HINTS FOR YOUR RECIPROCATING SAW
If your power tool becomes too hot, set the speed to maximum and run a no load for 2-3
minutes to cool the motor.
Always ensure the work-piece is firmly held or clamped to prevent movement.
The blade guard must be held firmly against the material being cut to reduce saw
vibration, blade jumping and blade breakage.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
ENVIRONMENTAL PROTECTION
This product has been marked with a symbol relating to removing electric
and electronic waste. This means that this product shall not be discarded
with household waste but that it shall be returned to a collection system which
conforms to the European Directive 2002/96/CE. It will then be recycled or dismantled
in order to reduce the impact on the environment. Electric and electronic equipment
can be hazardous for the environment and for human health since they contain
hazardous substances
To Next Page
Loading...
Need help?
General
