jcb JS260

3 - 1
Dismantling
1. Clean the idler wheel with a suitable solvent. Remove
the plug A from hub B and drain the oil.
2. On one side of the unit only, remove the wire clip E or
roll pin F and separate the hub C from shaft D.
3. Remove 'O'-ring I from shaft D. Pull out the shaft D from
the idler wheel G.
4. Remove the wire clip E or roll pin F and separate hub C
from shaft D. Remove 'O'-ring I from shaft D.
3.
Remove 'O'-ring I from shaft D. Pull out the shaft D
from the idler wheel G.4. Remove the wire clip E or
roll pin F and separate hub C from shaft D. Remove
'O'-ring I from shaft D.
Section J
Track and Running Gear
9803/6400
Section J
3 - 1
Issue 2*
Idler Wheel
A
B
G
D
C
E
H
F
I
G
D
C
D
I
F
C
E
*