JCM DBV 200 - DBV 200 In-Field Test Mode

DBV
TM
200: In-Field
Stand-Alone Test Mode
Set the Dip switches then apply power to the unit to
accomplish this function
Note: Perform this test outside the game using the game power (6-
pin) connector, or power supply hook-up
• Before applying power, turn Dip switch “6” to “On”.
• Apply power, then turn Dip switch “6” to Off. The unit should
cycle.
• The unit is ready for stand-alone testing
• Insert a Bill/Note. It will either be accepted and go completely
through the bill head, or be rejected.
• If the unit rejects the Bill/Note, refer to the “Bill Return Codes”
table.
• If the unit will not take the Bill/Note in, check the “Abnormal
Initialization Codes” table.
• When the unit cycles on power up, this indicates power and forward
motor operation.
• When you insert a plain piece of paper and it is rejected, this
indicates reverse motor operation.
• When you insert various denominations of currency and they are
accepted, this indicates the Bill/Note was accurately matched
against the characteristics of the software version.