The push button ignition can be placed in the following
modes:
OFF
•
The engine is stopped.
•
Some electrical devices (e.g. power locks, alarm,
etc.) are available.
ACC
•
Engine is not started.
•
Some electrical devices are available (power win-
dows, etc.).
RUN
•
Driving position.
•
All electrical devices are available.
START
•
The engine will start.
NOTE:
In case the ignition switch does not change with the
push of the START/STOP ignition button, the key fob
may have a low or depleted battery. In this situation, a
backup method can be used to operate the ignition
switch. Put the nose side of the key fob (side with the
mechanical flip key) against the START/STOP ignition
button and push to operate the ignition switch.
CAUTION!
•
Do not press the mechanical key against the
START/STOP ignition button.
•
Do not use sharp metal objects (e.g. screwdriver
etc.) to pry the button out of the ignition switch.
This button comes as an assembly, and is not
removable. This can damage the silicone shield.
WARNING!
•
When exiting the vehicle, always remove the key
fob from the vehicle and lock your vehicle.
•
Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
(Continued)
WARNING!
•
Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or oth-
ers could be seriously or fatally injured. Children
should be warned not to touch the parking brake,
brake pedal or the gear selector.
•
Do not leave the key fob in or near the vehicle, or
in a location accessible to children, and do not
leave the Keyless Enter ‘n Go™ Ignition in the
ON/RUN position. A child could operate power win-
dows, other controls, or move the vehicle.
•
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat buildup may
cause serious injury or death.
CAUTION!
An unlocked vehicle is an invitation for thieves.
Always remove key fob from the vehicle and lock all
doors when leaving the vehicle unattended.
NOTE:
When opening the driver's door with the ignition in the
ON/RUN (engine not running) position, a chime will
sound to remind you to place the ignition in the OFF
position. In addition to the chime, the message will dis-
play “Ignition Or Accessory On” in the cluster.
Backup Starting Method
Do Not Use Mechanical Key
18 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
