To install the Door Off Mirrors, proceed as follows:
1. Remove both front doors
page 25.
2. Remove the cowl bolt closest to the door opening
using a #40 Torx head driver, and store in a safe
location.
3. Push the mirror bracket forward onto the A-pillar,
making sure to align the bottom of the bracket with
the upper door hinge, and the hole from the
removed cowl bolt.
4. Place the bracket bushing behind the mirror bracket
(over the cowl bolt hole), then insert the bracket bolt
into the mirror bracket, through the bracket bushing.
5. Insert the hinge shoulder bolt through the bottom of
the upper door hinge up into the mirror bracket,
then rotate the bracket knob toward the rear of the
vehicle to secure the mirror bracket to the A-pillar.
6. Tighten both the bracket bolt and the hinge shoul-
der bolt with a #40 Torx head driver. Recommended
torque specification for the bracket bolt is 6 ft-lb
(8 N·m), and 7.5 ft-lb (10 N·m) for the hinge shoulder
bolt.
7. Lower the mirror assembly onto the mirror bracket.
Cowl Bolt Location
Push Bracket Onto A-pillar
Attaching Mirror Bracket To The Vehicle
1 — Bracket Bushing
2 — Bracket Bolt
Attaching Mirror Bracket To The Vehicle
1 — Bracket Knob
2 — Hinge Shoulder Bolt
GETTING TO KNOW YOUR VEHICLE 31
2
To Next Page
Loading...
