Removing The Rear Window And
Quarter Panel Cover Assemblies
NOTE:
Both quarter panel cover assemblies and the rear window
must ALL
be removed together, or installed together.
1. Start by removing the rear window first. Use the two
straps located on the bottom of each side of the
rear window to remove the right and left vertical
retainers, as well as the lower center retainer.
2. While keeping the rear window level, slide it outward
in either direction until it is completely separate
from its retainer. Do not pull downward while
removing the rear window. Damage to the retainer
could result. Store the rear window in the soft top
rear window storage bag (if equipped), or in a safe
location
page 76.
3. After removing the rear window, remove the quarter
panel cover assemblies starting with either side.
Disengage the quarter panel cover assembly from
the bottom by pulling the fabric at the bottom
upward.
4. With two hands, grab the front of the quarter panel
cover assembly and pull outward to disengage it
from its retainer on the door frame.
5. Pull the quarter panel cover assembly up and out
from the bottom, then pull it down and away from
the vehicle to remove.
6. Repeat this procedure for the other quarter panel
cover assembly. Store the assemblies in the soft top
rear window storage bag (if equipped), or a safe
location.
Step One (Right Side Shown)
Step One
Step Two
Step Four
Step Five
GETTING TO KNOW YOUR VEHICLE 75
2
To Next Page
Loading...
