1. Fold down the sun visor against the windshield.
2. Turn the three L-shaped locks on the left side panel
(one at the front, the rear, and outside), unlocking
them from the roof.
3. Unlatch the left side header panel latch located at
the top of the windshield.
4. Remove the left side panel.
5. Repeat the previous steps to remove the right side
panel.
Hard Top Panel(s) Storage Bag —
If Equipped
The Freedom Top panels storage bag allows you to
store your hard top panels. The storage bag contains
two compartments.
Lay the bag for the panels down so the loops and hooks
are facing upward. Unzip the bag and fold back the
outer flap.
NOTE:
•
Ensure the front panel latch is closed prior to insert-
ing the panel into the panels bag.
•
There is a pouch located on the front of the bag to
store the provided hard top edge protectors that are
used when the hard top is not installed on the
vehicle.
1. Insert the left side hard top panel into the bag with
the latches facing upward.
2. Unfold the black panel divider (ensure the divider is
lying flat).
3. Insert the right side Freedom Top panel into the bag
with the latches facing downward.
NOTE:
Ensure the front panel latch is closed prior to insert-
ing the panel into the bag.
4. Unfold the outer flap and zip the hard top bag
closed.
5. Store the Freedom Top panels bag in a safe
location.
Step Two
1 — Rear Panel Lock
2 — Front Panel Lock
3 — Outside Panel Lock
Step Three
1 — Header Panel Latched
2 — Header Panel Unlatched
Step Four
GETTING TO KNOW YOUR VEHICLE 83
2
To Next Page
Loading...
