EasyManua.ls Logo

Jeep Gladiator 2024 - Starting and Operating; Starting the Engine; Manual Transmission - if Equipped; Automatic Transmission - if Equipped

Jeep Gladiator 2024
316 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STARTING AND OPERATING
STARTING THE ENGINE
Before starting your vehicle, adjust your seat, adjust
both inside and outside mirrors, and fasten your seat
belts.
WARNING!
When exiting the vehicle, always remove the key
fob from the ignition and lock your vehicle.
Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or oth-
ers could be seriously or fatally injured. Children
should be warned not to touch the parking brake,
brake pedal or the gear selector.
Do not leave the key fob in or near the vehicle, or
in a location accessible to children. A child could
operate power windows, other controls, or move
the vehicle.
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up may
cause serious injury or death.
MANUAL TRANSMISSION
IF EQUIPPED
Apply the parking brake, place the gear selector in NEU-
TRAL, and press the clutch pedal before starting the
vehicle. This vehicle is equipped with a clutch interlock-
ing ignition system. It will not start unless the clutch
pedal is pressed to the floor.
Four-Wheel Drive Models Only
In 4L mode, if the vehicle is stalled, the engine will start
regardless of whether or not the clutch pedal is pressed
to the floor. This feature enhances off-road perfor-
mance by allowing the vehicle to start when in 4L with-
out having to press the clutch pedal. The 4WD LOW
Indicator Light will illuminate when the transfer case
has been shifted into this mode.
AUTOMATIC TRANSMISSION
IF EQUIPPED
Start the vehicle with the gear selector in the PARK
position (vehicle can also be started in NEUTRAL). Apply
the brake before shifting to any driving range.
NORMAL STARTING
To Turn On The Engine Using The ENGINE START/STOP
Button
1. The transmission must be in PARK or NEUTRAL.
2. Press and hold the brake pedal while pushing the
ENGINE START/STOP button once.
3. The system starts the vehicle. If the vehicle fails to
start, the starter will disengage automatically after
10 seconds.
4. If you wish to stop the cranking of the engine prior to
the engine starting, push the ENGINE START/STOP
button again.
To Turn Off The Engine Using The ENGINE START/STOP
Button
1. Place the gear selector in PARK, then push and
release the ENGINE START/STOP button. The igni-
tion will return to the OFF position.
2. If the gear selector is not in PARK (with vehicle
stopped) and the ENGINE START/STOP button is
pushed once, the transmission will automatically
select PARK and the engine will turn off, however
the ignition will remain in the ACC position (NOT the
OFF position). Never leave a vehicle out of the PARK
position, or it could roll.
3. If the gear selector is in NEUTRAL, and the vehicle
speed is below 5 mph (8 km/h), pushing the
ENGINE START/STOP button once will turn the
engine off. The ignition will remain in the ACC
position.
4. If the vehicle speed is above 5 mph (8 km/h), the
ENGINE START/STOP button must be held for two
seconds (or three short pushes in a row) to turn the
engine off. The ignition will remain in the ACC posi-
tion (NOT the OFF position) if the engine is turned
off when the transmission is not in PARK.
NOTE:
The system will automatically time out and the ignition
will cycle to the OFF position after 30 minutes of inac-
tivity if the ignition is left in the ACC or RUN (engine not
running) position and the transmission is in PARK.
115
4

Table of Contents

Related product manuals