WARNING!
•
ONLY install carpet designed to fit your vehicle.
NEVER install carpet that cannot be properly
attached and secured to your vehicle. If the carpet
needs to be replaced, only use manufacturer
approved carpet for the specific make, model, and
year of your vehicle.
•
If the vehicle carpet has been removed and
re-installed, always properly attach carpet to the
floor and check that the floor mat fasteners are
secure to the vehicle carpet. Fully depress each
pedal to check for interference with the accelerator,
brake, or clutch pedals then re-install the floor mats.
CARPET REMOVAL
Front Carpets:
1. Remove the front grommets.
2. Pull the carpet out from the front to the rear.
3. Remove the grommets under the front seat. First for
the rear carpet and then the front carpet.
4. Under the back of the front seat, open the carpet
split and then pull out the rear edge and slide the
carpet to the front (do not remove the harness).
5. Finally open the carpet split around seat bracket
and then remove the last two grommets.
6. When reinstalling carpet, perform these steps in
reverse order, making sure that the carpet is tucked
under the scuffs, B-pillar, and console, and then
refasten the grommets.
Front Carpet
1—Grommets
Front Carpet Pulled Away
Front And Rear Carpet Split
Rear Underside Of Front Seat Carpet Split
290 SERVICING AND MAINTENANCE
To Next Page
Loading...
