EasyManua.ls Logo

Jeep Gladiator 2024 - Half-Doors - if Equipped

Jeep Gladiator 2024
316 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. Insert the three mirror screws into the mirror assem-
bly, and tighten into the mirror bracket using a
#30 Torx head driver. Recommended torque specifi-
cation for the mirror screws is 4 ft-lb (5.5 N·m).
9. Repeat the steps on the other side of the vehicle.
NOTE:
If this kit is being installed with the optional lamp
bracket, the bracket bushing from step 4 is not needed.
Use the spacer from the lamp bracket.
HALF-DOORS IF EQUIPPED
CAUTION!
Do not run half-doors through an automatic car
wash. This may result in scratches and wax
buildup on the windows.
Careless handling and storage of the half-doors
may damage the seals resulting in water leaks into
the interior of the vehicle.
The upper half-doors must be positioned properly
to ensure sealing. Improper installation can cause
water leaks into the interior of the vehicle.
Store the zipper pulls of the upper half-door win-
dows at the upper B-pillar area for both front and
rear doors to avoid damage to the windows when
not in use.
Do not attempt to operate the half-door zipper in
temperatures of 41°F (5°C) or below. Damage to
the window may occur.
Use this QR code to access your digital
experience.
This vehicle may be equipped with half-
doors. To install the half-doors in the
vehicle, follow the instruction sheet
packaged in the box the doors were
received in. Replacement parts may be
purchased through Mopar® Service.
Half-Door Installation
To install the front or rear half-doors, proceed as
follows:
1. Remove the full doors from the vehicle. For front
door removal, see
page 24. For rear door
removal, see
page 28.
2. Locate the upper and lower hinge pins on the lower
half-door, and lower them into the body hinges on
the vehicle.
NOTE:
The upper hinge pin is longer, which can be used to
assist in guiding the door into place during
installation.
3. Insert the upper and lower hinge pin screws into the
body hinges. Tighten the screws using a #T50 Torx
head driver to 3.8 f lb / 5.2 N·m.
Lower Mirror Assembly Onto Bracket
Mirror Screw Locations
Scan me
Lower Half-Door Hinge Pins
GETTING TO KNOW YOUR VEHICLE 31
2

Table of Contents

Related product manuals