8. Fold the rear panel down; the tailgate can now be
raised and secured in place.
NOTE:
If not leaving the tailgate in the mid-position, the
Tonneau Cover must be closed completely prior to
fully closing the tailgate.
CAUTION!
Do not sit on the Tonneau Cover; damage to the cover
and/or cargo will occur.
TONNEAU COVER REMOVAL
To remove the Tonneau Cover, proceed as follows:
1. Open the tailgate.
2. Fold the rear panel of the Tonneau Cover forward to
reveal the red release straps.
3. Pull one of the red release straps to release the Ton-
neau Cover latch.
NOTE:
Pulling either strap will release the latches to roll the
Tonneau Cover up; there is no need to pull both at
the same time.
4. Roll the Tonneau Cover forward, starting with the
rear bar and continue to roll toward the front of the
truck bed.
5. Using the stowage straps, secure the Tonneau Cover
in the rolled up position.
6. Using a #T50 Torx head driver, remove the two fas-
teners securing the Tonneau Cover to the front of
the truck bed.
Tonneau Cover With Tailgate In Mid-Position
Release Strap Location
Roll Tonneau Cover Forward
Secured Tonneau Cover
96 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
