2. Using a #T50 Torx head driver, secure the fasteners
to the bed.
3. Lower the tailgate to the fully open position before
unrolling the Tonneau Cover.
4. Release the stowage straps used to secure the Ton-
neau Cover in the rolled up position.
5. Roll the Tonneau Cover rearward toward the back of
the truck bed.
6. Position both Tonneau Cover latches over the lock-
ing mechanisms (one on each side of the truck
bed), making sure the plastic retainer is correctly
seated in the forward part of the latch.
7. Once the rear Tonneau Cover bar is positioned over
the locking mechanism, grab the back of the Ton-
neau Cover and push downward on the center to
engage the locking mechanisms. Make sure an
audible “click” from both sides of the Tonneau Cover
is heard to confirm that the latch is completely
engaged.
NOTE:
If desired, the Tonneau Cover can be left in this
position (rear panel folded forward) while the tail-
gate is closed, or the tailgate can be raised to the
mid-position
page 92.
Release Stowage Strap
Roll Tonneau Cover Rearward
Correctly Seated Retainer
Incorrectly Seated Retainer
Push Downward To Lock
GETTING TO KNOW YOUR VEHICLE 95
2
To Next Page
Loading...
