BED RAIL TIE DOWN SYSTEM —
IF EQUIPPED
CAUTION!
The maximum load per cleat should not exceed
250 lb (113 kg) and the angle of the load on each
cleat should not exceed 45 degrees above horizontal,
or damage to the cleat or cleat rail may occur.
The Bed Rail Tie Down system allows you to properly
secure cargo in the truck bed.
There are two adjustable utility rail cleats on each side
of the bed that can be used to assist in securing cargo.
Each utility rail cleat must be tightened down in one of
the detents along either utility rail in order to keep
cargo properly secured.
To move the utility rail cleat to any position on the utility
rail, turn the cleat retainer nut counterclockwise several
times. Then, pull out on the utility rail cleat and slide it
to the detent nearest the desired location. Make sure
the utility rail cleat is seated in the detent, and tighten
the nut.
To remove the utility rail cleats from the side utility rails,
slide the cleat to the rectangular cutout located at the
end of the rail toward the front of the vehicle.
To remove the utility rail cleat from the front utility rail,
slide the cleat to the rectangular cutout located on the
left side of the rail.
TONNEAU COVER — IF EQUIPPED
The Tonneau Cover can be installed on the truck bed to
keep cargo out of view, and protect from inclement
weather.
The Tonneau Cover consists of the following features:
•
Easy roll up cover
•
Tonneau fore/aft locator
•
Crossbar inside bed locator
•
Rear latches
•
Stowage straps
NOTE:
The Tonneau Cover can be rolled up and secured at the
front of the truck bed without removing it completely.
TONNEAU COVER INSTALLATION
To install the Tonneau Cover, proceed as follows:
1. Position the rolled up Tonneau Cover on the truck
bed and align it to the two fastener locations at the
front of the bed.
Bed Rail Tie Down Locations
Adjustable Cleat Assembly
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
Fastener Locations
94 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
