EasyManua.ls Logo

Jeep Gladiator 2024 - Page 61

Jeep Gladiator 2024
316 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If equipped, the Locking Storage Bin is located below
the rear seats. It can be accessed by folding the rear
seat bottom upward into the Stadium Position.
The Locking Storage Bin has two keyed locks on the
front of the bin and uses the same key as the glove
compartment and the center console for your vehicle.
Inside the bin are three removable dividers to set up
storage that works best for you.
The Locking Storage Bin can be removed by unfasten-
ing the four bolts that attach the bin to the vehicle floor
using the provided #40 Torx head driver and ratchet.
The bottom of the storage bin has rubber mats that
need to be removed to access the four bolts. These
bolts can then be stored in the fastener bin below the
rear seat.
Your Locking Storage Bin also has a front handle that
makes it easier to carry and pull out from the floor of
the vehicle when the four bolts that attach the bin to
the floor are removed.
Rear Behind Seat Storage If Equipped
The rear wall storage bin is located behind the right
rear seat.
Rear Wall Storage Bin
To access the storage bin, pull upward on the pull strap
located on the upper outboard side of the right rear
seat, and fold the seatback forward.
NOTE:
The rear seatback can be locked using the vehicle key
to secure items in the rear wall storage bin. The seat
lock is located on the upper outboard side of each seat-
back. Both seatbacks should be locked to limit access
to items behind seat.
Rear Wall Netting
The rear wall netting can be accessed the same way as
the rear wall storage bin.
Fastener Bin
Your vehicle is equipped with a Fastener Bin used to
store the fasteners for the doors, windshield, and hard
top (if equipped) while not in use. The Fastener Bin is
located behind the rear seat storage bin. The Fastener
Bin contains foam inserts for each of the fasteners;
they are removable.
To remove the Fastener Bin:
1. Remove the lid and foam inserts from the Fastener
Bin.
2. Remove the three nuts from the bottom of the Fas-
tener Bin.
NOTE:
The soft top fasteners do not go in the Fastener Bin.
Under Seat Storage (Open View)
1 Key Locks
2 Removable Bolts
3 Handle
Rear Wall Storage Bin
1 Rear Wall Storage Bin
2 Pull Strap
Rear Wall Netting
GETTING TO KNOW YOUR VEHICLE 59
2

Table of Contents

Related product manuals