3. Using the provided 15 mm socket, remove the two
hex bolts and remove the wiper arms.
4. Move to the inside of the vehicle and lower both sun
visors.
5. Using the provided #T40 Torx head driver, remove
the four Torx head fasteners located along the inte-
rior of the windshield (two on each side of the
header trim).
NOTE:
Store all of the mounting bolts in their original
threaded holes and tighten for safekeeping, or in
the fastener bin located below the rear seat.
6. Lower the windshield gently until it contacts the tie-
down bumpers (if equipped).
7. Secure the windshield by passing a cinch strap
through the tie-down bumper on either side of the
hood and on the windshield frame. Tighten the strap
to secure the windshield in place.
CAUTION!
Do Not Overtighten! Damage to the windshield could
result.
Adaptive Cruise Control (ACC)/Forward
Collision Warning (FCW) Sensor
Protective Cover — If Equipped
Your vehicle may be equipped with a protective cover
that is to be used whenever the windshield is folded
down in order to protect the ACC/FCW sensor. To install
the cover, refer to the following instructions:
1. Secure the top part of the cover so that it hinges to
the header.
2. Swing the cover down and push on it so that it cov-
ers the opening.
3. Check to make sure the cover is secured properly.
NOTE:
Be sure to remove the cover before returning the wind-
shield to the normal position. Store the cover in the
cargo area.
Step Five
1 — Outer Torx Fasteners
2 — Center Torx Fasteners
Step Six
1 — Washer Nozzle
2 — Bumper
3 — Tie-Down
Protective Cover Installed
90 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
