Jeep UNIVERSAL CJ-2A - Page 11

B
LUBRICATION
LUBRIC.ATION SPECIFIC.ATIONS
MODELS CJ
-28 aND CJ -38
FIG. 14-LUBRICATION CHART-MODELS CJ·2A AND C".J-.IA
r
Chart
ITEM TO BE
No.
I:;.UBRICATED
I
--···-(-----------
1.
Chassis Bearings . .....
2.
Engine ...............
3.
Transmission and
Transfer Case . ......
4. Differentials:
Front ..............
Rear ...............
5.
Universal Joints
Front Axle .........
6.
Steering Gear . ........
7.
Universal Joints
Propeller Shaft ......
8.
Distributor:
Oiler ...............
Wick ..............
Pivot ..............
Cam ...............
9.
Generator and
Starting Motor** . ...
10.
Front Wheels .........
11. Rear Wheels** . .......
13.
Governor .............
14.
Power Take-Off .•.....
15. Universal Joints
Power Take-Off .....
Air Cleaner . ..........
Not lower than 32'F. [O'C.]
use SAE 30 or
lOW-30
FREQUENCY*
Each 1000 miles (1.600 km.l
Change each 2000 miles [3.200 km.l
{Check each 1000 miles 11.600 km.l
Change each 10,000 miles [16.000 km.l
{Check each 1000 miles [1.600 km.]
Change each 10,000 miles (16.000 km.]
{Check each 1000 miles [1.600 km.]
Change each 12,000 miles 119.200 km.]
Check each 1000 miles (1.600 km.l
Each 1000 miles [1.600 km.J
Each 1000 miles [1.600 km.!
Each 1000 miles (1.600 km.]
Each 1000 miles (1.600 km.]
Each 1000 miles (1.600 km.]
Each 1000 miles 11.600 km.!
Disassemble to lubricate each
6000 miles [9.600 km.]
Sparingly each 1000 miles [1.600 km.J
Check each 1000 miles [1.600 km.l
Check each 1000 miles (1.600 km.]
Extensive use: Repack once a year.
Each 2000 miles 13.200 km.J
As low as lO'F. [-12'C.I
use SAE 20, 20W.
lOW-30. or lOW-20
QUANTITY
i
LUBRICANT
GRADE
u.s. Imperial
Metric
TYPE
Summer I
Winter
-------------
As required
Chassis Lubricant
No.1 No. 0
4 qts. 3)i qts 3.785ltrs.
Engine Oil
See Note
3 Y. pts.
3 pts.
1.65 ltrs.
GL4
SAE 90 SAE 80
2 Y. pts.
2 pts.
1.18 ltrs.
MIL-L-2105B SAE 80 SAE 80
2%: pts.
2 >4" pts. 1.3 ltrs.
MIL-L-2105B
SAE 80
SAE80
As required Universal Joint Lubricantt
No.1
No. 0
As required MIL-L-2105B
SAE 80 SAE 80
As required Universal Joint Lubricantt·
No.1 No. 0
Several drops
Engine Oil
Same as engine
One drop
Engine Oil
Same as engine
One drop
I
Engine Oil
Same as engine
Sparingly Grease
Soft
2-4 drops Engine Oil
Same as engine
As required
Whed Bearing Lubricantt No.2
No.
2
As required Wheel Bearing Lubricantt
No.2 No. 2
As required
Engine Oil
Same as engine
As required
GL4 SAE80
SAE80
As required Chassis Lubricant
No.1 No. 0
lli pts. 1 pt. .591 ltrs. En~ine Oil
Same as engine
As low as -lO'F. [-23'C.]
use SAE lOW,
lOW-30, or lOW-20
Below -10'F. [-23'C.]
use SAE 5W or
5W-20
*This chart applies for usual road work. For additional lubrication requirements when used for field or industrial work, see Par. B-39.
**Starting motor bearings on Model CJ-3A nhicles after Serial No. 30972 were lubricated at assembly to last between normal rebuild periods.
***Rear wheels must be removed from Model CJ-2A vehicles before Serial No. 13413 to lubricate wheel bearings.
tSodium base lubricants recommen.:ied; do not mix sodium base and lithium base lubricants.
10