REMOTE TRANSMITTER OPERATION
The CONTINUUM S2 is equipped with a wireless, infrared (IR) remote transmitter, allowing
convenient wireless control of the most commonly used functions from the listening position.
An explanation of these functions and battery installation follows.
NOTE: Housing the integrated amplier in extremely high ambient light conditions may cause
erratic remote control operation. The IR sensor, located within the volume level display, must
not be exposed to direct sunlight or spotlights.
(1) DISPLAY DIM: Press once to dim display one level of
brightness. Press again to resume default level of
brightness.
(2) INPUT SELECT 1-4: The IN 1, IN 2, IN 3, and IN 4
buttons will select the desired input. The input number
corresponding to the numbering of the inputs on the
rear panel.
(3) INPUT SELECT 5 BYPASS: The IN 5 button will select
the BYPASS input.
(4) MUTE: This button will immediately mute the outputs
of the integrated amplier. The volume display will
continue to show the present location of the volume
control. Pressing this button a second time will
reactivate the outputs of the integrated amplier.
(5) VOL UP: The VOL UP button will increase the output
level of the integrated amplier in 0.5 dB increments.
Holding this button down will cause the volume level
to continuously increase until the button is released or until 99.5 is displayed on the
volume display.
(6) VOL DOWN: The VOL DOWN button will decrease the output level of the integrated
amplier in 0.5 dB increments. Holding this button down will cause the volume level to
continuously decrease until the button is released or until 00.0 is displayed on the volume
display.
(7) PHASE: Press once to invert absolute phase. PHASE LED on front panel will light. Press
again to return integrated amplier to non-inverted absolute phase. PHASE LED on front
panel will turn off.
REVA1.9 - CONTINUUM S2 INTEGRATED AMPLIFIER
PAGE 17
To Next Page
Loading...
Need help?
General
