7
Speaker Output
The three speaker output buttons (A SPEAKER (27), B SPEAKER (28) and C SPEAKER (29))
control speaker output from the radio. A SPEAKER (27) also controls the output of the rear line
level audio out. Press any of the three buttons to turn the corresponding speaker sets on or off.
SPK A, SPK B or SPK C will appear on the display.
Reset
The reset button should be activated for the following reasons:
Initial installation of the unit when all wiring is completed
Function buttons do not operate
Error symbol on the display
Use a ball point pen or thin metal object to press the reset button (16).
HDMI ARC
Connect HDMI cable to JENSEN TV with ARC function and JWM9A head unit. If the set
up and operation is correct, the TV audio will come out from the speaker of the head unit
after switching to HDMI ARC mode.
See the ARC function Operation in the following table:
Power Off
(Last mode
is HDMI
ARC before
Power OFF)
Power ON
(Last mode
before
power off)
Power Off
(Last mode
is HDMI
ARC before
Power OFF)
TV, AV,
USB, HDMI
(non-HDMI
ARC)
If the TV can
play the device
automatically,
there will be TV
audio out.
Otherwise,
switch to USB
mode to play
the device.
TV, AV,
USB, HDMI
(non-HDMI
ARC)
Switch TV to
another mode
(such as TV, AV,
USB, non-HDMI
ARC mode)
Switch to
HDMI ARC
Mode and
Audio out
from Head
unit in HDMI
ARC mode
TV, AV,
USB, HDMI
(non-HDMI
ARC)
Switch Head unit to
another mode
(Such as FM,
Bluetooth, DVD
or AUX)
No audio
out (No
HDMI ARC
Audio Out)
TV, AV,
USB, HDMI
(non-HDMI
ARC)
TV, AV,
USB, HDMI
(non-HDMI
ARC)
TV CEC Mode ON
Audio Receiver ON