•
5. Winch
Attach winch cable to object, or if vehicle to the "T" slots in the frame
If the vehicle does not have "T" slots, attach"
J"
hooks to the vehicle's
frame only. With the towed vehicle's transmission in neutral and brakes
released. winch the vehicle onto the deck to its transport position (See
winch operating instructions). Secure the load against movement in all
directions. Set brakes if a vehicle.
Q
>::&6
Leave winch cable attached and taut. Anchor front of
vehicle or load with safety tie downs to keyslots provided
in front of the deck. Winch cable is not intended to tie
down load.
Always winch load onto deck, never drive a vehicle onto
the tilted deck.
Make sure that the load is side-to-side centered.
Remain clear of load when winching onto deck.
CAUTION:
CAUTION:
6. Roll
Lower the roll control handle to roll the deck up the incline until the deck
Is in the proper position for tilting.
NOTE: The alignment decal on the rubrail must be even with the red
control handle, or slightly behind that handle, when leveling
the deck.
CAUTION:
CAUTION:
•
It>
6
Q~'
•
7. Tilt
Lower the front of the deck until the deck supports align with the wooc
strips on the frame.
~
NOTE: The deck must not be fully forward when tilting or it wil
damage the hold downs.
Rev. _
2.2
Oale _
Eastern Wrecker Sales Inc
To Next Page
Loading...