Jester Operating Manual Run Mode
22 of 52 Jester Manual 73-403-00 Issue 3.2
minimum end of its rotation which stops automatic stepping through a chase and gives full manual
control, using the INSERT button.
ATTACK
The attack button lets you switch between various modes for chases. Again, each chase is grabbed
by visiting its current value, then moving to the new value. The options are: Snap on, Snap off; Snap
on, Fade off; Fade on, Snap off; Fade on, Fade off.
DIRECTION
This button is used to override the direction that a chase memory runs in, when output. Again, you
must grab the current value of the active chases, then adjust to the new value. The accompanying
lights indicate which direction has been selected. A Random option is also provided, for the creation
of simple effects.
PROGRAM/GO
The PROGRAM/GO button is used to initiate a crossfade between the memory currently being output
and the next memory as indicated by the LCD.
Pressing the PROGRAM/GO button automatically increments the memory number in the LCD, and the
selection on the monitor.
Pressing PROGRAM/GO with SHIFT held down acts as a PAUSE button, stopping the crossfade
which is currently active. The crossfade can then be restarted by pressing the PROGRAM/GO button
again.
COPY/PASTE
The COPY function also works in RUN Mode, to allow looks to be stored, ready to PASTE into a
memory/submaster in PROGRAM Mode. The red light in the COPY/PASTE button is illuminated
when there is data available. To clear the buffer, press the button again and the light will go out.
NOTES
Remote Go
Pressing a switch connected to the Remote Input jack socket on the back panel has
the same effect as pressing the PROGRAM/GO button, by default. This can be
altered in SUPER USER.
Entering Run Mode
1. If the desk is in PRESET Mode or SUPER USER Mode, press and hold the
MODE button for 1 second. The desk will change to PROGRAM Mode. When the
desk is in PROGRAM Mode press the MODE button to enter RUN Mode.
2. Ensure that blackout is not active (the light in the BLACKOUT button is off).
3. Set all the PRESET faders and the A MASTER and B MASTER to zero.
4. Set the MEMORY MASTER and GRAND MASTER to full.
5. Set the FADE TIME control to the desired value.
NOTES
Editing ‘Live’
When changing from RUN Mode to PROGRAM Mode, it is the NEXT memory which
will be selected for editing. To make an edit to the current memory without sudden
output changes, simply set the NEXT memory to the same as the CURRENT
memory, before changing from RUN Mode to PROGRAM Mode.
To Next Page
Loading...
Need help?
General