Jester Operating Manual Preset Mode
8 of 52 Jester Manual 73-403-00 Issue 3.2
Timed Crossfades between Scenes
1. Set the A MASTER and B MASTER to zero.
2. Set up a scene using the PRESET A faders.
3. Set up a different scene on the PRESET B faders.
4. Set the FADE TIME control to the time required to fade scene A in.
5. Quickly move the A MASTER to full. The scene on the PRESET A faders will fade
in and be output live. (The time taken for the fade to complete is determined by
the value set on the FADE TIME control).
6. The red FADING light will flash while the dipless crossfade is taking place, and go
out when the crossfade is complete
7. To crossfade to the scene on PRESET B, quickly move the A MASTER to zero
and the B MASTER to full. The scene on PRESET B will fade in and the scene on
PRESET A will fade out in the time defined by the FADE TIME control. The red
FADING light will flash during the crossfade.
8. A new scene can then be set up on PRESET A without affecting the outputs.
9. To crossfade to the scene on PRESET A, quickly move the A MASTER to full and
the B MASTER to zero. The scene on PRESET A will fade in and the scene on
PRESET B will fade out in the selected time. The red FADING light will flash while
the dipless crossfade is taking place, and go out when the crossfade is complete.
Flashing Channels – Two Preset Mode
1. Ensure that the flash function is active. To do this, use the cursor up/down keys
to alter the flash mode between Off, Flash and Solo.
2. Press and hold an individual CHANNEL FLASH button. (Those below the
PRESET A faders or PRESET B faders can be used). The channel is then added
to the scene at the level set on the GRAND MASTER.
3. Release the CHANNEL FLASH button. The channel returns to its previous (fader)
level.
FLASH: The selected channels will be sent to full when the button is pressed, and
will be returned to its fader level when the button is released. No other channels are
affected.
SOLO: The selected channels will be sent to full and all other channels will be sent
to blackout. When the button is released, all channels are returned to their fader
levels.
To Next Page
Loading...
Need help?
General