Jet BD-920N - Belt Replacement and Electrical Setup; Replacing the V-Belt; Electrical Connections

Replacing the V-Belt
Loosen the screw on the top of the headstock and open
the cover. (Fig. 39)
Remove tension on the V-belt by pulling handle toward
front of the machine. (Fig. 39) Remove belt from the
pulleys and replace with new belt Move lever toward
motor to tension belt. (Fig. 40) Close cover and secure
with screw.
Caution: to avoid breaking the belt, move the tension
lever towards the front of the machine before starting.
(Fig. 41)
Electrical Connections
The BD-920N Bench Lathe is rated at 3/4 HP, 1 Ph., 60
HZ, 115V only Confirm the power at the location is the
same as the rating of the lathe before plugging the lathe
in. Do not attempt to run this lathe on any other type of
power.
The lathe must be properly grounded The lathe is
designed to be used with an outlet as in Fig. 42. If this
type of outlet is not readily available, an adapter (as in
Fig. 43) may be used temporarily until a qualified
electrician can install a grounded outlet Make sure the
grounding tab on the adapter is secured to the cover
plate screw.
Fig. 40
Fig. 42 16
Fig. 43