To Next PageTo Next Page
Need help?Do you have a question about the Jet BD-920W and is the answer not in the manual?
Explains what is covered, who is covered, warranty period, and exclusions.
Outlines how to obtain service, state law implications, and limitations of liability.
Critical safety information regarding proper grounding and electrical connections for the tool.
Comprehensive safety guidelines for operating the lathe, including workspace, attire, and tool handling.
Safety rules for checking parts, preventing unexpected starts, and awareness of chemical hazards in dust.
Details machine capacities such as swing over bed, distance between centers, and overall dimensions.
Technical specifications for headstock, gearbox, carriage, tailstock, and other major assemblies.
Instructions for unpacking the lathe, identifying all parts, and checking for shipping damage.
Steps for cleaning, preparing surfaces, and recommended electrical setup for the lathe.
Overview of the lathe's main parts including the bed, headstock, drive system, carriage, apron, tailstock, lead screw, and gearbox.
Identification and purpose of all controls, switches, levers, and handwheels on the lathe.
Guide to tool setup, manual turning, and engaging automatic longitudinal feed for machining.
Instructions for taper turning, turning between centers, and thread cutting methods.
Description of chucks, drill chuck, centers, steady rest, and follow rest for work manipulation.
Details on the four-way tool post and information on change gears for speed and feed selection.
Procedures for adjusting main spindle bearings and gibs for cross and top slides.
Steps for adjusting feed screws, replacing the shear pin, and maintaining the V-belt.
Comprehensive guide to daily lubrication points for all machine components.
Exploded views and parts lists for the headstock and drive assemblies.
Exploded views and parts lists for the gearbox and apron assemblies.
Parts lists and diagrams for the saddle, cross slide, tailstock, and lathe bed components.
Diagram illustrating the electrical connections and motor wiring for the lathe.
General
