21
Lubrication Schedule
(Figures 40 and 41)
Figure 40
Note: Lubricate all locations daily.
Grease refers to #2 tube grease.
Oil refers to 20W machine oil.
1 – 1 to 2 squirts of oil into oil ball on gear hub.
2 – Grease teeth of feed and change gears.
1 to 2 squirts of oil into oil ball on gear hub.
3 – Lightly Coat gear teeth with oil.
1 to 2 squirts of oil into oil ball on gear hub.
4 – Wipe bedways clean and coat lightly with oil.
5 – Grease rack over complete length.
6 – Clean and oil leadscrew over complete length.
7 – 1 to 2 squirts of oil into oil ball on leadscrew
bracket.
8 – Lightly coat screw and guides of top slide with
oil.
9 – 1 to 2 squirts of oil into oil ball on top of tailstock
body.
10 – 1 to 2 squirts of oil into oil ball on top of
carriage.
11 – 1 to 2 squirts of oil into hub for feed lever.
12 – 1 to 2 squirts of oil into two oil balls on apron
front.
Figure 41
To Next Page
Loading...
