Jet BD-920N - General Safety Warnings

A WARNING
1 Read and understand the entire instruction
manual before operating machine
2. Always wear approved safety glasses/face
shields while using this machine
3. Make certain the machine is properly
grounded
4 Before operating the machine, remove tie,
rings, watches, other jewelry, and roll up
sleeves above the elbows Remove all
loose clothing and confine long hair Do
NOT wear gloves,
5 Keep the floor around the machine clean
and free of scrap material, oil and grease
6 Keep machine guards in place at all times
when the machine is in use If removed for
maintenance purposes, use extreme
caution and replace the guards
immediately
7, Do NOT over reach Maintain a balanced
stance at all times so that you do not fall or
lean against blades or other moving parts
8 Make all machine adjustments or
maintenance with the machine unplugged
from the power source
9 Use the right tool Don't force a tool or
attachment to do a job which it was not
designed for,
10, Replace warning labels if they become
obscured or removed
11, Make certain the motor switch is in the OFF
position before connecting the machine to
the power supply
12, Give your work undivided attention. Looking
around, carrying on a conversation, and
"horse-play’ 1 are careless acts that can
result m serious injury.
13 Keep visitors a safe distance from the work
area
14 Use recommended accessories; improper
accessories may be hazardous
15 Make a habit of checking to see that keys
and adjusting wrenches are removed
before turning on the machine.
16 Never attempt any operation or adjustment if
the procedure is not understood.
17. Keep fingers away from revolving parts and
cutting tools while in operation.
18 Keep belt guard in place and in working
order
19 Never force the cutting action
20 Do not attempt to adjust or remove tools
during operation.
21. Always keep cutters sharp
22. Always use identical replacement parts
when servicing.
23 Failure to comply with all of these warnings
may cause serious injury
22. WARNING: Some dust created by power
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known to cause cancer, birth defects of other
reproductive harm
Some examples of these chemicals are
• Lead from lead based paint
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from chemically-
treated lumber.
23. Your risk from those exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are specifically
designed to filter out microscopic particles
1