Jet BD-920N - Page 4

Table of Contents
Warnings.1
Table of Contents.2
Specifications.3
Contents of the Shipping Container.3
Set-Up and Preparation for Operation.3
General Description.4-6
Controls.7
Operation.8-13
Adjustments.14-16
Electrical Connections.16
Lubrication Schedule.17
Parts Lists and Breakdowns.18-41
Wiring Diagram.42
CAUTION
The three jaw chuck and the face plate have a set screw on their flanges that secures them to the
threaded spindle. Before removing the three jaw chuck or the faceplate, remove the set screw
completely from the flange. Failure to remove the set screw may cause damage to the threads on
the spindle. When installing either the three jaw chuck or the faceplate, tighten the set screw
firmly to prevent the chuck or the faceplate from coming off the spindle during operation.
The specifications in this manual are given as general information and are not binding. JET
Equipment and Tools reserves the right to effect, at any time and without prior notice, changes or
alterations to parts, fittings, and accessory equipment deemed necessary for any reason whatsoever.
2