General safety notes
Milling machines can be dangerous if
not used properly. Therefore the
appropriate general technical rules as
well as the following notes must be
observed.
Read and understand the entire
instruction manual before attempting
assembly or operation.
Keep this operating instruction close by
the machine, protected from dirt and
humidity, and pass it over to the new
owner if you part with the tool.
No changes to the machine maybe
made.
Daily inspect the function and existence
of the safety appliances before you start
the machine.
Do not attempt operation in this case,
protect the machine by unplugging the
mains cable.
Do not wear gloves while operating this
machine.
Remove all loose clothing and confine
long hair.
Before operation the machine, remove
tie, rings, watches, other jewelry, and
roll up sleeves above the elbows.
Wear safety shoes; never wear leisure
shoes or sandals.
Always wear the approved working
outfit:
- Safety goggles
- Ear protection
- Dust protection
Install the machines so that there is
sufficient space for safe operation and
workpiece handling.
Keep work area well lighted.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled table
surface.
Make sure that the power cord does not
impede work and cause people to trip.
Keep the floor around the machine
clean and free of scrap material, oil and
grease.
Stay alert！
Give your work undivided attention.
Use common sense. Do not operate the
machine when you are tired.
Keep an ergonomic body position.
Maintain a balanced stance at all times.
Do not operate the machine under the
influence of drugs, alcohol or any
medication. Be aware that medication
can change your behavior.
Never reach into the machine while it is
operating or running down.
Never leave a running machine
unattended. Before you leave the
workplace switch off the machine.
Keep children and visitors a safe
distance from the work area.
Do not operate the electric tool near
inflammable liquids or gases.
Observe the fire fighting and fire alert
options, for example the fire
extinguisher operation and place.
Do not use the machine in a dump
environment and do not expose it to
rain.
Metal dust is explosive and can also
represent a risk to health.
Dust form some tropical woods in
particular, and form hardwoods like
beach and oak, is classified as a
carcinogenic substance.
Always use a suitable dust collection
device.
Before machining, remove any nails
and other foreign bodies from the
workpiece.
Make sure to guide and hold the chisel
with both hands safe and tight during
machining.
Work only with well sharpen tools.
Machine only stock which is chucked
securely on the machine, always check
before switching the machine on.
Provide workpieces with center holes
before clamping between centers.
Work large and unbalanced workpieces
at low spindle speed only.
Workpieces with cracks may not be
used.
Remove the chuck key or dowel pins
before turning the machine on.
Always close the belt cover.
Specifications regarding the maximum
or minimum size of the workpiece must
be observed.
Test each set-up by revolving the work
by hand to insure it clears the tool rest
and bed. Check setup at the lowest
speed before you increase to the
operating speed.
Do not remove chips and workpiece
parts until the machine is at a standstill.
Never stop workpiece with the hand
during run out.
Do not attempt to engage the spindle
lock pin until the spindle has stopped.
Never tale measurement on a rotating
workpiece.
Do not stand on the machine.
Connection and repair work on the
electrical installation maybe carried out
by a qualified electrician only.
Have a damaged or worm power cord
replaced immediately.
Make all machine adjustments or
maintenance with the machine
unplugged from the power source.
To Next Page
Loading...
Need help?
General
